Operation
Safety strut
BA RD18 en 01
55
3.01 Safety strut
WARNING
Unintentional movement of the machine!
Severe injury or death due to unexpected machine movement during
setting work.
■
Do not connect or disconnect the safety strut unless the engine is
stopped and the ignition is set to off.
■
Park the machine on safe ground, i.e., flat and horizontal ground
with sufficient bearing capacity.
■
Secure machine against rolling away.
The steering block prevents uncontrolled movements of the steering
system. This therefore prevents the machine's front or rear vehicle from
swinging out.
Always engage the steering block before:
■
Crane-loading the machine.
■
Transporting the machine.
■
Maintenance and repair work.
NOTE
Before engaging the steering block, safely park the machine
without a steering lock (set the steering to driving straight).
Applying the steering block
Undo the retaining bracket [1] from the coupling bar [4].
Remove the bolt [2].
Move the coupling bar [4] from the upper mounting [3] to the lower
mounting [5].
Use the bolt [2] to lock the coupling bar [4] in the lower mounting [5].
Slide the retaining bracket [1] onto the coupling bar [4].
a
Steering block is applied.
To Next Page
Loading...
Need help?
General
