Operation
Driving with additive sprinkling system
BA RD18 en 01
95
3.19 Driving with additive sprinkling system
The additive sprinkling moistens the tyres with a separating compound.
The wetting prevents that bitumen sticks on tyres when laying blacktops.
This is the way to make a neat and even covering.
NOTE
The frequency of sprinkling depends on the temperature of
the tyres. Cold tyres must be moistened more often than
warm ones. Prior to driving on hot blacktops take care that
the running surfaces of the wheels are clean and sufficiently
moistened.
NOTE
The emulsion may only be mixed of parting agent concentrate
and water according to the indications of the parting agent
producer (Observe regulations for environment protection).
Switching the additive-sprinkling system on and off
Prerequisites:
■
Version of the machine as a combination roller
■
Electrical system ON
■
No chip spreader mounted as an additional device.
Press and hold the switch [1] or foot pedal [2].
a
Additive sprinkling takes place for as long as one of the switches is
held down.
a
When the switch is pressed [1]: Indicator LED [3] on.
Release the switch [1] or foot pedal [2].
a
Additive sprinkling stops.
a
The indicator LED [3] is off.
To Next Page
Loading...
Need help?
General
