Operation
Driving
82
BA RD18 en 01
The machine's low drum width and high centre of gravity increase the
risk of tipping when driving fast around corners and when navigating
transverse inclines.
Drive the machine at a moderate speed!
In all driving situations, observe the machine's permitted transverse in-
cline! (see "Technical data", page 169)
3.13.01 Seat contact switch
The machine may only be operated from the driver's seat. The machine
is equipped with a seat contact switch to ensure this. If the driver rises
from their seat while driving, the seat contact switch is activated and the
machine brakes after a delay.
WARNING
Fast automatic braking!
Delayed, fast braking of the machine that starts automatically can lead
to serious injuries or death.
■
Only drive the machine when seated.
■
Do not use the function of the safety switch to stop the machine.
■
Brake and stop the machine with the driving lever.
Driver's seat monitoring
If the driver gets up from the seat while driving,
a
an acoustic signals sounds immediately.
If the driver does not react,
a
the machine is braked to a standstill after a total of 3 seconds and
the operating functions are deactivated.
a
The diesel engine continues running.
If the driver sits back down within two seconds of leaving the driver's
seat, no braking procedure is initiated.
If the machine is braked by the safety switch, the machine has to be
brought into the home position before operation can be resumed.
Bring the machine into the home position – drive on after the
delayed braking
Prerequisites:
■
The machine is at a standstill, after delayed braking.
■
Driver sitting on the seat again.
■
Diesel engine is running.
Move the drive lever to position 0.
a
The operating functions are active again.
To Next Page
Loading...
Need help?
General
