Operating manual Spray wall Basic 8000
4 Basic Safety Instructions
14 Order number 3305595 | Edition 07/2022
4 Note the details provided by the powder lacquer manufacturer.
4 To correct for dust deposits, only mobile industrial vacuums of type1 may be used (see
EN60335-2).
4 Take measures for workplace safety (see Chapter "A Safe Work Environment").
4.2.7 Maintenance and Repair
Danger due to improper maintenance and repair!
Danger to life and equipment damage.
4 Only a WAGNER service center or a specially trained person may carry out repairs and
replace parts.
4 Repair or replacement of devices or parts of devices are only allowed to be performed
outside the hazard area by qualified personnel.
4 Use only WAGNER original spare parts and accessories.
4 WAGNER assumes no liability for changes to the product made by the operating
company without the knowledge of WAGNER. Any adjustments to the documentation
and the market release are the responsibility of the operating company.
4 Only repair and replace parts that are listed in the chapters "Accessories" and "Spare
Parts" and that are assigned to the device.
4 Do not use any defective components.
4 Before all work on the device and in the event of work interruptions:
4 Switch off the energy and compressed air supply.
4 Relieve pressure on spray gun and device.
4 Secure the spray gun against actuation.
4 Observe the operating and service manual for all work.
To Next Page
Loading...
Need help?
General
