Operating manual Spray wall Basic 8000
11 Disassembly and Disposal
Order number 3305595 | Edition 07/2022 35
11 DISASSEMBLY AND DISPOSAL
11.1 DISASSEMBLY
WARNING
Incorrect disassembly!
Risk of injury and damage to the device.
4 Before starting disassembly:
4 Switch off the energy and compressed air supply.
4 Ensure the grounding of all system components.
4 Secure system against being switched back on without authorization.
4 Observe the operating manuals when carrying out all work.
We recommend having the WAGNER system disassembled by WAGNER or another specialist.
Before starting disassembly, all supply media (electric current, compressed air) must be
disconnected at the connection points. All powder lacquer lines must be completely
emptied and then rinsed. Lacquer residues must be disposed of in line with statutory
requirements.
Before starting disassembly, check and ensure that the supply lines have actually been
interrupted and have been depressurized and/or de-energized if necessary.
The empty system should be thoroughly cleaned. In particular, fire loads, such as unused
lacquers in exhaust air pipes, etc. for example, should be removed to keep the risk of fire
during disassembly as low as possible.
11.2 DISPOSAL
Separate all materials encountered during disassembly as clearly as possible in line with
statutory requirements. Carry out appropriate measures to ensure that no dangerous
substances can enter the system as it is being disassembled. All waste produced must be
separated and disposed of in line with the applicable regulations.
Used materials are:
– Steel
– Cables ...
To Next Page
Loading...
Need help?
General
