Operating manual Spray wall Basic 8000
7 Operation
Order number 3305595 | Edition 07/2022 25
7 OPERATION
7.1 TRAINING THE OPERATING PERSONNEL
– The operating personnel must be qualified to operate the entire system.
– The operating staff must be familiar with the potential risks associated with improper
behavior as well as the necessary protective devices and measures.
– Before work commences, the operating personnel must receive appropriate system
training.
7.2 TASKS
1. Ensure that:
4 the regular safety checks are carried out in accordance with Chapter Safety Checks
[829];
4 commissioning is carried out in accordance with Chapter Assembly and
Commissioning [818].
7.3 SWITCHING ON THE SYSTEM
1. Switch on the compressed air.
2. Switch on the main switch (1).
3. Switch on the ventilator (2).
The spray gun is released for coating in the booth or spray wall, if all the necessary signals
provided by the customer are present.
NOTICE
Insufficient air volume!
If the cleaning operation is not activated, the nominal exhaust output is not reached.
7.4 SWITCHING OFF THE SYSTEM
During every interruption of operation, all powder feeding parts of the entire coating system
should be cleaned of residual powder.
1. Switch off the powder feed and the high voltage for the spray gun and secure them
against being switched on unintentionally.