39
OPERATING MANUAL
VERSION 02/2013 ORDER NUMBER DOC 2333548
7.2.1 SPRAYING
7.2.2 PRESSURE RELIEF / WORK INTERRUPTION
If the system has been used with two component materials:
7.2 WORK
1. Secure gun and place nozzle in the gun in accordance with the gun manual.
2. Slowly open the ball valve (2).
3. Set required working pressure on the pressure regulator (1).
4. Optimize the spraying results as laid down in the gun instructions.
5. Start work process.
1. Close gun.
2. Close ball valve (2).
3. Release the system by opening the gun.
4. Close and secure gun.
5. Open and close the return valve (3) to completely depressurize the system.
Hardened material in the spraying system when 2-component material is
processed!
Destruction of pump and injection system.
Follow the manufacturer‘s processing rules, particularly regarding the pot life.
Flush thoroughly before the end of the pot life.
The pot life is decreased by warmth.
NOTICE
To Next Page
Loading...
Need help?
General
