20
W&T Assigning/Changing IP Parameters
3.1 Managing the network parameters in the USB-Server
The W&T USB-Server distinguishes between two modes with
respect to its network-side basic parameters..
Static
IP address, subnet mask and gateway are stgored in the non-
volatile setup of the USB-Server, and DHCP protocol is disabled.
The parameters set using this method remain stored even after
power interruptions and resets until they are changed using
WuTility or Web-Based-Management.
DHCP (factory default setting)
DHCP protocol is enabled and the USB-Server attempts to
obtain its IP parameters from a DHCP server located in the
network. If no DHCP server can be accessed or the attempt to
obtain an IP address is rejected, the USB server operates using
the factory default IP address 190.107.233.110. When
switching from Static to DHCP mode using WuTility or Web-
Based-Management, the USB-Server reverts to this default IP
address until valid new parameters are assigned.
To Next Page
