W&T 53641 - Starting and Navigating the WBM; Navigation Concept of the USB-Server

50
W&T Web-Based-Management
6.1 Starting and navigating the WBM
To access the WBM of the USB-Server, start your Internet browser
and enter the IP address of the USB-Server and a port number if
appropriate.
http://[IP-Adresse]:[port number]
Ab Werk ist für das WBM der HTTP-Standard-Port 80 konfigu-
riert. In diesem Fall kann die Angabe der Portnummer in der
Adresszeile entfallen.
The factory default setting is for HTTP standard Port 80. In this
case you do not need to enter the port number in the address
line.
6.1.1 Navigation concept of the USB-Server
The WBM of the USB-Server is session-oriented using a
password-protectedlogin. Without a login the start page simply
shows basic information but does not permit any changes to
the settings.
After loggin in you can make any unber of settings during a
configuration session. Clicking on the Apply button on the
respective pages causes them to be temporarily stored by the
USB-Server. Once all the settings have been made, exit the
configuration session and use Logout and click on Save. Only
now are all changes sent to the non-volatile memory of the
USB-Server and activated..
You can exit a configuration session at any time without saving
your changes by clicking on the Cancel button.
1
To ensure errorless running of the configuration
sessionwe recommend that when within the WBM only
the nvaigation links provided by the USB-Server be used rather
than the Back and Forward function of the browser.