28
W&T Assigning/Changing IP Parameters
After clicking on the Continue button you are also prompted
for the system password. Then the network parameters are
stored in the USB-Server in non-volatile memory.
All further settings are made using Web-Based-Management of
the USB-Server and an Internet browser. Select the desired USB-
Server from the WuTility inventory list and click on the Browser
button.
Additional information about management of the USB-Server
can be found in the section Web-Based-Management.
1
Changing the network parameters is protected by the
system password. To prevent unauthorized use, we
recommend assigning a system password for operating Com-
Servers.
3.3.2 Assigning static IP parameters using WBM
As shipped and after a reset to the factory default settings the
USB-Server is in DHCP mode. As long as no address is assigned
using a DHCP server, the USB-Server can also be reached in par-
allel through its default IP address 190.107.233.110. Switching
to Static mode and assigning the new IP parameters can also
be done using Web-Based-Management and a browser.
1
In contrast to address assigning using WuTility, initial
startup of multiple USB-Servers using the methods
described in the following can be done only in sequence. Only
after a USB-Server has received its new IP address can the next
USB-Server be connected to the network.
To Next Page
Loading...
