26
W&T Assigning/Changing IP Parameters
3.3 Static mode
In Static mode the USB-Server uses static network parameters
and DHCP protocol is disabled. There are two ways of assigning
the static values for IP address, subnet mask and gateway.
3.3.1 Assigning static IP parameters using WuTility
The Windows tool WuTility in version 3.70 and higher supports
inventorying and management of the network basic parameters
of W&T USB-Servers:
• IP address
• Subnet mask
• Gateway address
• Umschaltung Static/DHCP
To assign these parameters the PC and USB-Server must be
located in the same physical network, whereby the function is
independent of the current address settings of the USB-Server.
This means even if the current parameters of the USB-Server do
not match the settings of the PC, you can still always use
WuTility to make a change. Any system password set in the
USB-Server must however be known.
Installing WuTility
The quickest way to install WuTility is using the Install button
on the start screen of the product CD included with the
product.
Then start WuTility using
Start r Programs r W&T Software Toolkit r WuTility
Starting the assignment dialog
Be sure that both the USB-Server and the computer are
connected to the same physical network. After starting, WuTility
automatically searches the local network for connected W&T
network devices and creates an inventory list. This search
To Next Page
Loading...
