Installation manual
11
487 14 59 11 - TD30 TD50 TD75 US
Gas Information
It is your responsibility to have ALL plumbing connections made by a qualified professional to
insure that the installation is adequate and conforms with local and state regulations or codes. In
the absence of such codes, ALL plumbing connections, material, and workmanship must conform
to the applicable requirements of
the National Fuel Gas Code ANSI Z223.1 or the CAN/CGA-B149, INSTALLATION CODES -
both the latest edition.
IMPORTANT: Failure to comply with these codes or ordinances, and/ or the requirements
stipulated in this manual, can result in personal injury and improper
operation of the dryer.
The dryer must be isolated from the gas supply piping system by closing its individual manual
shut-off valve during any pressure testing of the gas supply piping system at test pressures equal
to or greater than
1
/
2
psig (3.5 kPa).
IMPORTANT: Failure to isolate or disconnect the dryer from the gas supply as noted can cause
irreparable damage to the gas valve and will VOID THE WARRANTY.
WARNING: FIRES or EXPLOSION COULD RESULT.
Gas Supply
The gas dryer installation must meet the American National Standard, National Fuel Gas Code
Z223.1-LATEST EDITION, as well as local codes and ordinances and must be done by a qualified
professional,
NOTE: Undersized gas piping will result in ignition problems,
slow drying, increased use of energy, and can create a safety hazard.
The dryer must be connected to the type of heat/ gas indicated on the dryer data label. If this
information does not agree with the type of gas available, do not operate the dryer. Contact your
local dealer or the Wascomat Sales Department.
IMPORTANT: Any burner changes or conversions must be
made by a qualified licensed professional.
The input ratings shown on the dryer data label are for elevations of up to 1,999 feet. The
adjustment or conversion of the dryer(s) in the field for elevations over 2,000 feet are made by
changing each burner orifice.
If these conversions are necessary, contact your local dealer or the Wascomat Sales Department.