Installation manual
39
487 14 59 11 - TD30 TD50 TD75 US
Gas installation general
Conversion to propane gas / natural gas
If the machine is to be converted to another type of gas, the gas
nozzle must be replaced.
Contact your dealer, or Wascomat, for the part number of the
conversion kit appropriate for your altitude.
Please contact your dealer or Wascomat if the current gas type is
not
propane / natural gas.
1. Remove nozzle.
2. Mount the accompanying nozzle (1).
TD75 only: Air reducing plate (7) must be mounted when
converting to propane gas and dismounted when converting to
natural gas
3. Loosen the measuring branch screw (2) 1/4 turn; connect a
manometer to the measuring branch (2).
4. Connect the power and select a heat programme.
5. Start the dryer.
6. Set the nozzle pressure on setting screw (4) under nipple (3).
7 Check that the gas flame burns evenly and has a bluish colour.
8. Mount the cover screw (3).
The numbers in brackets refer to the page regarding the gas
valve.
Affixing the sign
After the conversion, the enclosed sign with the new gas type
printed on it must be affixed to the dryer data label to cover
previous gas data.
To Next Page
Loading...
