without damaging the tubing or degrading the seal formed by the door gasket. Nevertheless, the
bottom edge of the door gasket is not designed for tubing egress because such a design can
cause the compartment door gasket to incompletely seal or the closed door to inadvertently open.
Notice: To avoid less-than-optimal performance of the column compartment and its
potentially damaging effect on running samples, ensure that the column-compartment
tubing is properly routed and secured in tubing retainers so that the compartment door
properly closes during system operation.
2.6
Controlling the column compartment
To control the 30-cm CH or 30-cm CHC module, enter its compartment temperature settings
using the sample manager's control panels or the method editor in Empower software or
MassLynx software. For details, refer to the Waters console Help.
December 5, 2017, 715004751 Rev. C
Page 53
To Next Page
Loading...
