Waters ACQUITY Arc - Securing the Column Compartment to the System Stack

2.1.3 Securing the column compartment to the system stack
When properly installed, the 30-cm CH or 30-cm CHC module is secured to the system stack by
the three standoffs and an adaptor bracket. The weight of the column compartment is supported
by the four legs attached to its base.
To secure the column compartment to the system stack:
1. Align the key-hole slots in the column-compartment adaptor bracket with the 3 standoffs on
the right-hand side of the system stack.
Figure 2–5: Key-hole slots on column-compartment adaptor bracket
December 5, 2017, 715004751 Rev. C
Page 25