RS232/485 TO WIFI POE ETH (B) User Manual
www.waveshare.com
Web Page Configuration: Access the built-in web page, navigate to the wireless terminal settings
page, and enable the AP+STA functionality to configure AP+STA settings.
As shown in the figure:
Figure Wireless networking application (AP+STA)
5.2.4 WIRELESS NETWORKING APPLICATION (AP, STA)
The RS232/485 TO WIFI POE ETH (B) device's wireless functionality can be configured in two
modes: as a wireless Station (STA) or as an Access Point (AP). Logically, it supports two wireless
interfaces: one acting as a STA to connect to an existing wireless network, and the other interface
serving as an AP, allowing other STAs to connect to the wireless network through this device.
AT+TCPPTB=18899
(6) Restart the WIFI serial server:
The No.1 WIFI serial server works in STA mode and No. 2 works in AP mode:
To Next Page
Loading...