VW Golf VII / Golf VII Sportsvan / Passat and Skoda Superb
Ident. No.: 1325133C_EN Status: 09.06.2017 © Webasto Thermo & Comfort SE
8
Preliminary Work for Passat
Preliminary Work for Golf VII / Golf VII Sportsvan
Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
•Depressurise the cooling system.
• Disconnect and remove the battery completely together with the carrier.
• Completely remove the air filter box together with the intake hose.
• Remove the engine underride protection.
• Remove the right underride protection.
• Remove the fuel tank underride protection, if present.
• Remove the right front wheel.
• Remove the front right wheel well trim.
• Remove the lateral instrument panel trim on the driver's side (in case of Telestart).
• Remove the A-pillar trim on the driver's side (in case of Telestart).
• Remove the footwell trim on the right and the left.
• Remove the lateral instrument panel trim on the front passenger's side (in case of ThermoCall,
Golf VII).
• Remove the lower and upper A-pillar trim on the front passenger's side (in case of ThermoCall,
Golf VII).
• Remove the rear bench seat (in case of Golf VII).
• Remove the right rear seat (in case of Sportsvan).
• Open the right-hand tank-fitting service lid.
Heater
• Remove years that do not apply from the type and duplicate label.
• Attach the duplicate label (type label) visibly in the appropriate place in the engine compart-
ment.
Vehicle
• Open the fuel tank cap.
• Ventilate the fuel tank.
• Close the fuel tank cap again.
•Depressurise the cooling system.
• Disconnect and remove the battery completely together with the carrier.
• Remove the air filter completely, together with the intake hose.
• Remove the engine underride protection.
• Remove the right underride protection.
• Remove the fuel tank underride protection, if present.
• Remove the right front wheel.
• Remove the front right wheel well trim.
• Remove the storage compartment.
• Remove the lateral instrument panel trim on the driver's side.
• Remove the A-pillar trim on the driver's side (in case of Telestart).
• Remove the footwell trim on the front passenger's side.
• Remove the rear bench seat.
• Open the right-hand tank-fitting service lid.
Heater
• Remove years that do not apply from the type and duplicate label.
• Attach the duplicate label (type label) visibly in the appropriate place in the engine compart-
ment.
To Next Page
Loading...
