Weber mt TRC 66 - Changing the Vibrator Oil; Put the Compactor out of Operation as Described in; Figure 17

TRC66-86 *** 41
3.3.7 Changing the Vibrator Oil
- Put the compactor out of operation as described in
paragraph 2.9.
Caution!
Change the vibrator oil at operating temperature
and with the compactor in the horizontal position
only.
- Put an appropriate oil pan under the oil drain screw
(17/1).
- Clean the environment of the oil filler screw and the
drain screw.
- Undo the oil filler screw (17/2).
- Undo the oil drain screw (17/1).
Danger !
Danger of scalds because of hot oil.
When the used oil has been completely drained:
- Replace the oil seals of the oil drain screw and the oil
filler screw.
- Screw the oil drain screw (17/1) down.
Danger to the Environment !
Dispose of the collected used oil in an
environmentally-friendly manner.
- Top up with vibrator oil (refer to paragraph 3.4 for
quantities and specifications).
- Screw the oil filler screw (17/2) down.
Figure 17
1
2