Weber Genesis 330 User Manual

12
CONNECTING THE LIQUID PROPANE CYLINDER
m WARNING: Make sure that the LP cylinder or regulator valve
is closed.
A) Connect LP cylinder.
Some regulators push ON to connect, and pull OFF to disconnect, others have a
nut that has a left-hand thread that connects to the cylinder valve. Follow one of the
specific regulator connection instructions illustrated based on your regulator type.
a) Screw regulator fitting onto tank turning clockwise (1). Position the regulator so
that the vent hole (2) faces down.
b) Screw regulator fitting onto tank turning anti-clockwise (3) (4).
c) Make sure regulator lever (5) is in the down/off position. Push regulator down on
tank valve until regulator snaps into position (6).
d) Make sure regulator lever is in the off position. Slide the collar of the regulator
up (7) (9). Push the regulator down onto the tank valve and maintain pressure.
Slide collar closed (8) (10). If regulator does not lock, repeat procedure.
◆
1
2
43
5
6
7
8
9
10
43
GAS INSTRUcTIONS

Weber Genesis 330 Specifications

General

BTU Main Burners	38, 000
BTU Sear Burner	10, 000
BTU Side Burner	12, 000
Grate Material	Porcelain-enameled cast iron
Burner Material	Stainless Steel
Ignition	Electronic
Fuel Type	Propane
Burners	3
Warranty	10 years