Weber Genesis 330 User Manual

WWW.WEbER.cOm
®
9
GAS INSTRUcTIONS
INSTALLING THE CYLINDER
Purchase a Full Cylinder of Gas From your Gas Dealer
The cylinder must always be installed, transported and stored in an upright position.
Never allow the cylinder to drop or be handled carelessly. Never store the cylinder where
temperaturescanexceed51°C(toohottoholdbyhand).Forexample,donotleave
the cylinder in your car on hot days. (Refer to: “SAFE HANDLING TIPS FOR LP GAS
CYLINDERS”).
Cylinder Bracket Installation
You will need: the cylinder brackets (1).
A) Open the grill cabinet. The cylinder brackets snap into the mounting holes in
the base panel as shown in the illustration (2). Insert cylinder bracket tabs into
rectangular slots. Secure in place by pivoting brackets down to lock centre tab in
place.
B) Lift and place the cylinder between the cylinder brackets (3) on the base panel. The
base of the cylinder must fit between the cylinder brackets (4).
C) Turn the cylinder so the valve opening faces the front of the barbecue.
Be sure that the cylinder brackets are installed in the base panel and that the base of
the cylinder fits within the cylinder brackets.
2
3
4
1

Weber Genesis 330 Specifications

General

BTU Main Burners	38, 000
BTU Sear Burner	10, 000
BTU Side Burner	12, 000
Grate Material	Porcelain-enameled cast iron
Burner Material	Stainless Steel
Ignition	Electronic
Fuel Type	Propane
Burners	3
Warranty	10 years