Weber Genesis 330 User Manual

28
mAINTENANcE
ELECTRONIC IGNITION SYSTEM OPERATIONS
If the Electronic Ignition System fails to ignite, be sure there is gas flow by attempting to
match-light your burners. Refer to “MAIN BURNER MANUAL IGNITION”. If match-lighting
is successful, the problem lies in the electronic ignition.
m WARNING: All gas controls and supply valves should be in
the OFF position.
• VerifythattheAAbattery(alkalineonly)isingoodconditionandinstalledcorrectly
(1). Some batteries have a plastic protective wrap around them. This plastic must be
removed. Do not confuse this plastic with the battery label.
• Makesuretheignitionwiresareattachedtoignitermoduleproperly.Refertothe
“IGNITER MODULE WIRE GUIDE” below.
• Makesuretheceramicigniterassemblyisfullypositionedintoburnertubeigniter
channel (2). If properly positioned, you will hear a snap (3).
• MakesuretheElectronicIgnitionbuttonisworkingbylisteningandlookingforsparks
at burner.
If the Electronic Ignition System still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site.
Log onto www.weber.com
®
.
◆
IGNITER mODULE WIRE GUIDE 330
1
2
3
4
1
2
34
A BCD
Wire End & Terminal Colour Burner Tube
Black (1) Left Burner (A)
Yellow (2) Right Burner (B)
Blue (3) Centre Burner (C)
Green (4) Sear Burner (D)
1
2
3

Weber Genesis 330 Specifications

General

BTU Main Burners	38, 000
BTU Sear Burner	10, 000
BTU Side Burner	12, 000
Grate Material	Porcelain-enameled cast iron
Burner Material	Stainless Steel
Ignition	Electronic
Fuel Type	Propane
Burners	3
Warranty	10 years