Wega Concept - Preparation of beverages; Programming the coffee doses; Coffee preparation; Programming the hot water doses

22
Wegaconcept
Technical manual
13.3 Programming the hot water doses
To program the hot
water doses, proceed as
follows:
place the cup under the •
hot water nozzle (12);
press and hold down •
the "PROG/STOP" key
on the left push-button
panel until all dose key
LEDs are switched on;
press the hot water de-•
livery key
;
when the desired dose has been reached, con rm by •
pressing the hot water key
again;
repeat the operation for the other dose button;•
upon completion of the programming, press the •
“PROG/STOP” key.
12
13 Preparation of beverages
13.1 Programming the co ee doses
To program the dose keys, proceed as follows:
press and hold the “• PROG/STOP” key down for 5 sec-
onds: the LED of the “PROG/STOP” key will  ash and
all keys on the push-button panel being programmed
will turn on;
 ll the  lter with a dose of ground co ee and press it •
with the co ee press;
attach the  lter holder to the delivery group;•
place the co ee cup under the delivery spout (• 16);
press the desired dose •
key (e.g.: “1 Espresso”
);
wait for the delivery;•
to confirm the desired •
dose press the dose key
or the "PROG/STOP" key
again;
once the dose is con-•
 rmed, the programmed key LED switches o and
only the keys yet to be set remain on;
repeat this operation for the other dose buttons;•
upon completion of the programming, press the •
“PROG/STOP” key to exit dose programming.
16
13.2 Co ee preparation
Fill the  lter with a dose of ground co ee and press •
it with the co ee press;
attach the  lter holder to the delivery group;•
place the co ee cup under the delivery spout (• 16);
press the desired dose key (e.g. “• 1 Espresso”
) and
wait for co ee delivery (all LEDs switch o , except for
that on the selected key).
to stop delivery of co ee in advance, press the deliv-•
ery key again or press the “PROG/STOP” key.
i
After idling for 30 seconds, the machine will
automatically exit the dose programming mode,
con rming the already programmed ones.
i
The programming of each dose must be carried
out with ground co ee and not with previously
used grounds.
!
It is possible to program all the push-button panels
of the machine simultaneously using only the left
push-button panel. To obtain di erent doses for
the various groups, perform the programming with
the left push-button panel  rst, and then with all
the others.
i
All models are provided with 2 keys for the delivery
of hot water. These can be programmed individually
and supply doses which are independent from one
another.
i
The 4GR version has 2 hot water nozzles. The left key
controls the left hot water nozzle, while the right
key controls the right hot water nozzle.