Wega Concept - Cleaning

29
Wegaconcept
Technical manual
ENGLISHOperation
Carry out the washing operations on the other groups,
following the same procedures indicated above.
If desired, the washing request can be forced by
pressing and holding the () key of the
programming selector for 5 seconds.
remove the  lter holder from delivery group 1 and •
press the “PROG/STOP” key.
wait for the rinse cycle to be carried out (this takes •
roughly 30 seconds), and the following messages will
appear on the display:
at the end of the rinse cycle, the following messages •
will appear on the display:
18 Cleaning
For perfect hygiene and e ciency of the unit, a few
simple cleaning tasks are required.
The indications given here are applicable for normal
use of the coffee machine. If the machine is used
intensively, the cleaning should be performed more
frequently. When cleaning, always use cloths that are
completely clean and hygienic.
Cleaning
Daily
Weekly
Monthly
CAPPUCCINO MAKER
Clean it several times a day as indicated in chap.
14.2, especially if used continuously
XXX
FILTERS and FILTER HOLDERS
Use a screwdriver to detach the  lter from the  lter
holder.
Let the  lters and  lter holders soak in hot water
for a few hours so that the fatty co ee deposits can
dissolve.
It is advisable to add special detergent to the water
and then rinse with clean water.
XXX
FILTERS and FILTER HOLDERS
Use a screwdriver to detach the  lter from the  lter
holder.
Clean the inside of the  lter holder with a brush and
wash the  lter and  lter holder with hot water.
Failure to clean the  lters and  lter holders may
compromise the quality of the co ee and cause
problems such as bad delivery and co ee grounds at
the bottom of the cup.
X
STEAM NOZZLE, AUTOSTEAMER
Keep the nozzle clean at all times using a cloth
dampened in lukewarm water.
X
STEAM NOZZLE, AUTOSTEAMER TERMINALS
Check and clean the tips of the nozzle, clearing out
the steam outlet holes with a small needle.
X
GR.1 RINSE
GR.2 ADD DETERGENT
GR.3 ADD DETERGENT
GR.4 ADD DETERGENT
GR.1 END OF WASHING OK
GR.2 ADD DETERGENT
GR.3 ADD DETERGENT
GR.4 ADD DETERGENT
GR.1 RINSE
GR.2 STOP/PROG KEY
GR.3 STOP/PROG KEY
GR.4 STOP/PROG KEY
GR.1 END OF WASHING OK
GR.2 STOP/PROG KEY
GR.3 STOP/PROG KEY
GR.4 STOP/PROG KEY
i
The washing operations can also be carried out
simultaneously on several delivery groups. To exit
the washing phase, the washing must be completed
on all the groups.
i
To disable automatic display of the wash request or
to modify the time of activation of the message, see
the chapter "Programming".
i
Before starting the washing phase with the PROG/
STOP key, you can cancel the operation by pressing
the () key. To exit a washing phase that is already
in progress, the washing must be completed of all
the groups.