Wega Concept - Programming; Access to the programming; Browser key

38
Wegaconcept
Technical manual
22 USB drive
The USB drive provided can be used to save all the
settings made on the machine.
If necessary, it's also possible to operate in reverse,
i.e., load the previously
saved data from the drive to
automatically reset all the
machine parameters.
The various procedures are
described below.
22.1 Data saving
Insert the USB drive in the appropriate reader (• 7);
press the (• ) key and wait for the data to be com-
pletely saved;
when  nished, all the con gurations on the •
machine will be saved on the USB drive.
23 Programming
This paragraph deals with the programming menu
that allows the user to program the various functions
of the machine.
It also explains how to reset the machine by reloading
the default manufacturer's data to the memory.
23.1 Access to the programming
To access machine programming, proceed as
follows:
insert the USB drive in the program reader (• 7), the
browser key will light up;
hold down the • ENTER but-
ton for at least 5 seconds.
The display will show the
programming menu.
23.2 Browser key
All the machine programming operations carried out
using the browser key.
During the programming phase a menu will
be displayed, from which it's possible to select the
parameters to be changed.
01 SERV. BOILER PRESS
02 COFFEE WATER TEMP.
03 GROUPS TEMPERAT.
04 CUP HEATER TEMP.
Browser key
22.2 Restoring data
Insert the USB drive in the appropriate reader (• 7);
press the (• ) key and wait for the data to
be completely loaded;
when  nished, all the con gurations saved •
on the USB drive will be transferred onto
the machine.
7
7
DATA SAVING OK
LOADING DATA OK
SAVING IN PROGRESS
LOADING IN PROGRESS
!
Do not remove the USB drive during data transfer.
i
The menu item, or the parameter that has been
selected, will  ash. To exit the menu, press the
( or () key.