Wega Concept - Programming group washing

48
Wegaconcept
Technical manual
23.18 Programming group washing
To program the automatic noti cation of delivery
group washing request proceed as follows:
ENTER
(x 5 secs.)
Hold down the ENTER button for at least 5 seconds.

Scroll the menu until the item is highlighted
13 NEW PROGRAM
14 DELIVERY TEST
15 GROUP WASHING
16 NUMBER OF GROUPS
ENTER Con rm to access the menu
START ON WASHING
YES/NO

Enable or disable the request for automatic washing of
the groups at machine start-up

Con rm pressing () to move to the next screen.
WASHING TIME/CYCLO
HH:MM N=X

Set the requested time for the washing of the groups

Move on to the next item.

Set the number of washing cycles ON-OFF (X).
ENTER Con rm to exit the menu.
13 NEW PROGRAM
14 DELIVERY TEST
15 GROUP WASHING
16 NUMBER OF GROUPS

To exit the programming menu
TEMPERATURE MODE
During the delivery, the temperature of the water
inside the delivery groups that are been used is
displayed.
T1, T2, T3, T4 = temperature in °C of the
delivery groups.
1,2 Bar Press 3,5
08:30 20-MAY-2010
T1=XX T2=XX
T3=XX T4=XX
FLOW MODE
In the last programming of coffee doses, the
system memorizes the  ow speed of the water during
delivery.
If "flow mode" is activated, the deliveries are
controlled by the system and are considered valid when
the speed of delivery is within the tolerance (± 30%) with
respect to the memorized one. If the delivery speed is
too fast or too slow, the system will display a message
suggesting to check the manual (refer to chapter "Display
noti cations")
i
By setting the "FLOW" mode, the machine will
only check the co ee dose keys. The "STOP/PROG"
key, if used for delivery, will not be subject to  ow
veri cation.
i
To perform cleaning operations, proceed as
indicated in chapter "Group washing". When
the machine is turned on, after the temperature
raises to operating levels, if set to YES, the display
shows the washing request. to disable the washing
request, set time to 00:00.