4
Wegaconcept
Technical manual
General warnings
The manufacturer of the equipment can not be held
responsible for damages caused by failure to oblige to
the requirements below.
Warnings for the installer
Read this manual carefully. It provides important •
information on safe installation, operation and main-
tenance of the equipment;
installation and maintenance of the equipment must •
be carried out by personnel quali ed and authorized
by the manufacturer, in compliance with safety regu-
lations and instructions included in this manual;
identify the model of the equipment. The model is •
shown on the packaging and on the nameplate of
the machine;
install the equipment only on sites where there is •
good ventilation;
do not obstruct the ventilation and exhaust holes on •
the machine;
do not tamper with the equipment components.•
!
After installing the machine, the installer is
required to ll in the "Installation Form" that goes
with the machine.
On this form must be con rmed the hygiene and
safety requirements in force on the installation
site and must be reported any notes relating to
changes or interventions necessary for the proper
functioning of the equipment.
Filled copies of the Installation form must be kept
by the user and by the installer until the end of life
of the machine.
In case of withdrawal of the machine, the installer
must also provide for the withdrawal of the user's
Installation form.
Typographical conventions
!
This symbol indicates that you must strictly follow
the instructions to which it refers in order to avoid
severe injury and/or damage to the machine.
i
This symbol provides additional information on the
operation of the machine and its components.
To Next Page
Loading...
