IE-SW-VL08M Series User’s Manual Featured Functions
3-3
Account
Setting Description Factory Default
admin admin privilege allows the user to modify
all device configurations.
user user privilege only allows viewing device
configurations.
admin
Password
Setting Description Factory Default
Old Password (Max.
16 Characters)
Type current password when changing the
password
None
New Password (Max.
16 Characters)
Type new password when changing the
password
None
Retype Password
(Max. 16 Characters)
If you type a new password in the
Password field, you will be required to
retype the password in the Retype new
password field before updating the new
password.
None
Accessible IP
An IP address-based filtering method to control access to Weidmueller switches.
Accessible IP Settings allows you to add or remove Legal remote host IP addresses to prevent
unauthorized access. Access to the Weidmueller switch is controlled by IP addresses. That is, if a
host’s IP address is in the accessible IP table, then the host will be allowed access to the device. You
can allow one of the following cases by setting this parameter
y Only one host with the specified IP address can access the IE-SW-VL08M
E.g., enter “192.168.1.1/255.255.255.255” to allow access to just the IP address 192.168.1.1.
y Any host on a specific sub network can access the IE-SW-VL08M
E.g., enter “192.168.1.0/255.255.255.0” to allow access to all IPs on the sub network defined by
this IP address/netmask combination.
To Next Page
Loading...
Need help?
General
