Weidmüller IE-SW-VL08M Series User Manual

IE-SW-VL08M Series User’s Manual Featured Functions
3-10
Setting Description Factory Default
1st Time Server
IP/Name
IP or Domain address (e.g., 192.168.1.1 or
time.nist.gov)
2nd Time Server
IP/Name
The device will try to locate the 2nd NTP
Server if the connection to the 1
st
NTP server
failed.
None
Time Server Query Period
Setting Description Factory Default
Query Period
This parameter determines how frequently the
time is updated from the NTP server.
600 seconds
Turbo Ring DIP Switch
The Turbo Ring DIP Switch page allows users to disable the four DIP switches located on the
switch’s outer casing. When enabled, the DIP switches can be used to configure basic settings for
either the “Turbo Ring” protocol or “Turbo Ring V2” protocol. A complete description of the
settings is given below.
NOTE
The “Turbo Ring” protocol (recovery time < 300 ms) provides better network reliability and faster
recovery time for redundant ring topologies. The “Turbo Ring V2” protocol (recovery time < 20
ms), supports additional redundant ring architectures.
In this manual, we use the terminology “Turbo Ring” ring and “Turbo Ring V2” ring to
differentiate between rings configured for one or the other of these protocols.
For a detailed description of “Turbo Ring” and “Turbo Ring V2,” please refer to the Using
Communication Redundancy section later in this chapter.
How to Enable or Disable the Turbo Ring DIP Switches
Enable / Disable the Turbo Ring DIP Switch

Weidmüller IE-SW-VL08M Series Specifications

General

Brand	Weidmüller
Model	IE-SW-VL08M Series
Category	Network Router
Language	English