上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
16 /33
6. Exchange positions of X1-axis and X2-axis and press F2.
The system automatically calculates the midpoint coordinate of X1-axis and X2-
axis separately based on the coordinates of X1-axis and X2-axis recorded in
step 5 and step 6, and separately sets the midpoints of X1-axis and X2-axis as
their workpiece origins.
Note: In single-axis mode, if you press F1 or F2, operations are only effective to X1-axis or X2-axis.
7. According to step 5 and step 6, set the the workpiece origin of Y-axis and press
F7 in Coor interface.
X-axis and Y-axis move to the workpiece origin specified by centering and Z-
axis is on the upper limit of workbench travel.
3 Quick Start
Through this section, you can quickly know the following machining processes for
Integrated CNC System for Shoe Molding Machines:
1. Load a program file.
2. Adjust the WCS.
3. Calibrate after tool changed.
3.1 Load a Program File
A shoe mold has multiple faces, and each face corresponds to a program file.
To load program files, do one of the following:
• To machine one face of a shoe mold, load a program file from the following path:
– The host: Program files saved in the root directory of the host
D:\\NcFiles.
– A USB flash disk: Program files saved in the root directory and
subdirectory of the USB flash disk.
– The internet: Program files saved in the host or the network.
It is similar to load a program file from these three paths. This section takes
Load a Program File from the Internet as an example.
• To machine the whole shoe mold at a time, set a machining task and load all
program files.
To Next Page
Loading...
