上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
28 /33
5 Parameter List
This part introduces the parameters for manufacturers.
5.1 Technic Parameters
N63000 Look Ahead Distance for Interpolation
The system looks ahead certain distance to analyze and calculate path interpolation.
The smaller the value, the slower the speed.
It is smooth when the value is within [0.2, 0.5].
N63001 Look Ahead Distance for Velocity
The system looks ahead certain distance to make speed planning at the connecting
angles.
N63002 Corner Tolerance
To improve the finish of the machined workpiece, the tool may not move to the
exact set position at two-segment connection. When difference of current position
and set position reaches value specified by this parameter, the system thinks the
machining is completed.
If the value is too large, the corner will become round.
Recommended value: ≤0.02.
N63006 Path Smoothing Time
The longer the time, the smoother the surface of the workpiece. But some of the
details may be weakened.
Recommended value: ≤0.02.
N64000 Startup F
The minimum feedrate in machining.
N64020 G00 F
The default speed in positioning.
N64040 F
The default feedrate in machining.
N64060 Max Feedrate
The maximum feedrate can be specified in program file or set by parameter N64040
Feedrate.
N64100 Axial Acceleration
The maximum acceleration of a single axis in machining.
N64101 Rapid Motion Axial Acceleration
In positioning, the maximum acceleration of a single axis.
To Next Page
Loading...
