WEIHONG NK300CX - Set a Machining Task

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
21 /33
3. Select Network → the target PC, find the desired shared folder, and click OK.
File list in the shared folder shows in Network interface.
4. To select the target program file, press ↑ or ↓.
5. To load the target program file for machining, press F1.
You can also do the following for a shared program file from the internet:
• F5: unload the loaded program file.
• F8: copy the target program file into the integrated CNC system.
3.1.2 Set a Machining Task
The system can automatically match the program files with technics and load all
matched program files at a time to improve efficiency.
To machine several faces of the shoe mold with one tool at a time, set the machining
task and then machine the shoe mold with the selected tool.
The default matching rules of program files with technics, workpiece coordinate
systems and A-axis coordinates are as follows:
Number
Technic
Program Name
WCS
A Coordinate
1
Inner
TOP
G54
A0
2
Bottom
BOT
G54
A0
3
Medial View
IN
G55
A0
4
Toe Cap
FN
G55
A90
5
Lateral View
OUT
G55
A180
6
Heel
BK
G55
A270
Before setting a machining task, ensure that parameter N80000 Support
Machining Tasks is set to Yes.
To set a machining task, do the following:
1. Press 1 → F3, and place the program files in the folder in the root directory of
the host.
Note: Files in the subdirectory of the host or from a USB flash disk and the internet cannot be read.