上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
23 /33
• To modify the workpiece coordinate system, press F3.
The supported workpiece coordinate system includes coordinate
systems G54 ~ G59 and extended coordinate systems G54P0 ~
G54P119. Before using extended coordinate systems, ensure
parameter N80010 Support Extended Part Offsets is set to Yes.
• To modify the A-axis coordinate, press F4.
5. After modification, click Save.
3.2 Adjust the WCS
In programming, programmers select a certain given point on workpiece as origin to
establish a new coordinate system. This operation is used to adjust the workpiece
coordinate system.
To adjust the workpiece coordinate system, do the following:
1. Select a WCS.
2. Set the offsets.
3.2.1 Select a WCS
For shoe module machines, two workpiece coordinate systems, G54 and G55, are
mainly used for machining:
• G54 is used to machine the upper and bottom of the shoe mold.
• G55 is used to machine the toe cab, heel, outside waist and inside waist of the
shoe mold.
Parameter N62023 Ignore Coordinate System Instruction (G code files) or
N65212 Ignore Coordinate System Instruction (ENG files) decides whether the
system automatically reads the WCS command in G code / ENG files:
• When it is set to Yes, this step is required, because the system ignores the WCS
commands in G code / ENG files.
• When it is set to No, the system automatically reads the WCS command in G
code / ENG files.
Before selecting a workpiece coordinate system, press → 1, and modify the
value of parameter N62023 Ignore Coordinate System Instruction / N65212
Ignore Coordinate System Instruction to Yes.
To Next Page
Loading...
