WEIHONG NK300CX - Set the Offsets

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
24 /33
To select a WCS , do the following:
1. In Auto mode, to enter Coor interface, press → 1.
2. Press N or click WCS input box and select a workpiece coordinate system.
– To select G54 (default setting), press F1.
– To select G55, press F2.
3.2.2 Set the Offsets
This operation is used to set the workpiece offset and the public offset. The former is
used to show the distance of the workpiece origin relative to the machine origin,
while the latter is used to adjust the workpiece origin of each axis for all workpiece
coordinate systems.
To set the offsets, do the following:
1. In Auto mode, to enter Coor interface, press → 1.
2. To set the workpiece offset, do the following:
1. To enable Modify in Part Offset area, press T, and input the
manufacturer password.
2. Click the target input box and input the value.
3. To set the public offset, do the following:
1. To enable Modify in Public Offset area, press H, and input the
manufacturer password.
2. Click the target input box and input the value.
3. Optional: To deepen (reduce) or lift (increase) Z-axis public offset,
press F7 or F8, and input the value.
The value is an accumulated value and it does not differentiate positive
value and negative value.
After setting, press T and H to disable modification to the workpiece offset and
public offset.