上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
30 /33
N64248 Enable Smooth Optimization
Whether to optimize the tool path in path smoothing or after Acc/Dec to improve
efficiency.
N64300 Deceleration Time To Pause
The time from running to pause or stop state.
Too short time may cause collision.
N64301 Deceleration Time To Soft Limit
The time from running to stop state on soft limit.
Too short time may cause collision.
5.2 Parameters for Approaching the Workpiece Surface
N62000 Deceleration Distance
In rapid positioning, spindle begins to decelerate in this distance and approaches
the target position at the speed specified by parameter N62001 Approaching F.
N62001 Approaching F
In rapid positioning, the feedrate of tools to approach the target position.
5.3 Parameters for Selecting Tools
N62022 Enable Tool Selection by G Code File
If there are several tools in G code file or other machining files that can be saved as G
code files, excluding Eng and NCE format files, tool selection function can be enabled.
5.4 Parameters for Selecting a Coordinate System
N62023 Ignore Coordinate System Instruction
Whether to ignore the coordinate system instruction, in G code file.
Yes: manually specify the workpiece coordinate system.
No: The system automatically reads workpiece coordinate systems in tool path files.
5.5 Spindle Parameters
N20001 Max. S
The maximum rotation speed of spindle.
It should match with the inverter setting.
N20002 S
The speed of spindle.
It should match the inverter setting.
N20010 Spindle On Delay Time
The delay time before turning on the spindle so that it can accelerate to the setting
speed.
It should match the inverter setting.
To Next Page
Loading...
