上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
17 /33
3.1.1 Load a Program File from the Internet
This operation is used to establish network connection between the integrated CNC
system for shoe molding machine and PC, to realize two-way transmission between
them.
To load a program file from the internet, do the following:
1. Set the IP address.
2. Verify the connection.
3. Access a shared program file.
3.1.1.1 Set the IP Address
This operation is used to establish the network connection channel between the
integrated CNC system and the PC by automatically obtaining or manually setting
the IP address.
It is default to automatically obtain the IP address. And this operation takes
manually setting the IP address as an example.
Before setting the IP address, ensure that the integrated CNC system and PC are in
the same subnet.
To manually set the IP address, do the following:
1. Press → 2 → F1. Network Setting dialog box pops up:
2. To not automatically obtain the IP address, press .
To Next Page
Loading...
