上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
32 /33
5.9 Parameters for Action after Cycle
N79100 Stop Mode when Cycle Completed
The tool motion after the cycle is completed.
0: stay where it is.
1: tool moves to fixed point.
2: tool moves to zero in WCS.
3: return machine home.
5.10 Feed Axis Parameters
N11000 Encoder Feedback
Whether to enable encoder feedback.
N11020 Axis Encoder Type
0: incremental encoder.
1: absolute encoder.
If an absolute encoder in non-bus control system is used, it should be used together
with Lambda 5M terminal board. Otherwise, it cannot work normally.
N16000 Driver Station Address
It should match toggle switch setting of the drive station address.
0 is invalid.
N16020 Encoder Digit
The encoder digit of a servo motor.
N74020 Coarse Positioning Dir.
The moving distance in coarse positioning stage in returning to the machine origin.
N74030 F in Coarse Positioning
The feedrate in coarse positioning stage in returning to the machine origin.
N74040 Coarse Positioning Switch Port Addr.
The PLC address of input port for the coarse positioning switch of each axis.
N74050 Fine Positioning Dir.
The moving distance in fine positioning stage in returning to the machine origin.
N74060 F in Fine Positioning
The feedrate in fine positioning stage in returning to the machine origin.
It is recommended to set this parameter to a small value to ensure accuracy of fine
positioning.
N74070 Fine Positioning Switch Port Addr.
The input port PLC address of fine positioning switch of each axis
To Next Page
Loading...
