上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
12 /33
3. In JOG / Handle / Step mode, press X+ to move X-axis, and observe its moving
direction.
4. Optional: If the actual moving direction is opposite to the judged direction,
modify the value of parameter Axis Direction(X) to the opposite value.
Example
The current value of parameter Axis Direction(X) is 1. And you find X-axis moves
towards the negative direction after pressing X+.
Then, you need to change the value of the parameter to -1.
2.3 Return to the Machine Origin
This operation is used to adjust the coordinate position before machining.
According to the encoder type, it can be divided into the following:
• Return to the machine origin with an incremental encoder.
• Set the datum with an absolute encoder.
To set the encoder type, press → 2 → F8, input the manufacturer password,
and modify the value of parameter N11020 Axis Encoder Type.
2.3.1 Return to the Machine Origin with an Incremental Encoder
This operation is used to return to a fixed point, i.e. machine origin, assigned by
design, manufacturing and debugging before the machine tool leaves factory.
Before returning to the machine origin with an incremental encoder, check the
motor nameplate and ensure the value of parameter N11020 Axis Encoder Type is
set to 0.
To Next Page
Loading...
