上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
18 /33
3. Press ↑ or ↓ to select the target input box, and set the following addresses:
– IP address
E.g. 192.168.1.188 (the first three digits should be the same with that of
PC, and the last digit should be different from that of PC)
– Subnet mask:
It is the same with PC.
– Default gateway:
It is the same with PC.
4. To close Network Setting dialog box and save the settings, press F7.
The new networking information shows in Network Connection Status area in
Computer interface.
3.1.1.2 Verify the Connection
This operation is used to verify whether the IP addresses are set successfully by
ping command after the IP addresses of the integrated CNC system and PC are set
well.
To verify the connection, do the following:
1. To open the command window, press Win and R keys on the keyboard of PC,
and input cmd in Run dialog box.
2. Input ping and IP address of the integrated CNC system.
E.g. ping 192.168.0.1
To Next Page
Loading...
