上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
29 /33
N64102 Z Axis Acceleration
The maximum acceleration of Z-axis.
Its value should match with the value of parameter N64100 Axial Acceleration.
N64120 Acceleration for Corners
The maximum acceleration of feed motion on adjacent axes.
N64150 Axial Jerk
The change rate of acceleration of a single axis.
It takes effect when parameter N64203 is set to 3.
N64201 Max Angle Smooth Velocity
If path corner angle is greater than the maximum one, the machine tool will move at
the startup speed instead of the automatically adjusted speed.
N64203 Path Interpolation Algorithm
0: trapezoid algorithm.
1: S-type algorithm.
2: LEP algorithm.
3: acceleration trapezoid algorithm.
N64204 Acc or Dec Time after Interpolation
The larger the value is, the smoother the speed will be.
This parameter has an effect on suppressing the vibration of the machine tool.
This parameter has no effect on track precision.
N64205 Min Velocity in LEP
The minimum velocity in LEP algorithm interpolation.
N64207 Arc Velocity Limit
Whether to enable the arc velocity limit.
N64208 Max. F of Reference Circle
The maximum velocity of the circle with 10mm diameter.
N64209 Min. F of Arc
The minimum velocity of the machine tool in arc motion.
N64244 Optimize Performance
Whether to make performance optimization in machining high precise tool path.
N64245 Pretreatment Path Number
The segments for performance optimization, having no effect on the result of
velocity planning.
It is set according to the host performance. Too great value will increase load for the
host.
To Next Page
Loading...
