WEIHONG NK300CX - Execute Selective Machining; Execute Machining; FAQs (Operator); Failed to Register the System

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
3.1.2 Set a Machining Task ......................................................................................... 21
3.2 Adjust the WCS ................................................................................................................. 23
3.2.1 Select a WCS .......................................................................................................... 23
3.2.2 Set the Offsets ...................................................................................................... 24
3.3 Execute Tool Calibration .............................................................................................. 25
4 FAQs .................................................................................................................................................. 26
4.1 Axis Servo Alarm ............................................................................................................. 26
4.2 Failed to Register the System ..................................................................................... 27
4.3 Drive 400 Alarm .............................................................................................................. 27
5 Parameter List .............................................................................................................................. 28
5.1 Technic Parameters ....................................................................................................... 28
5.2 Parameters for Approaching the Workpiece Surface ....................................... 30
5.3 Parameters for Selecting Tools .................................................................................. 30
5.4 Parameters for Selecting a Coordinate System ................................................... 30
5.5 Spindle Parameters ........................................................................................................ 30
5.6 Parameters for Z-axis Motion at Pause ................................................................... 31
5.7 REF Parameters ............................................................................................................... 31
5.8 Calibration Parameters ................................................................................................. 31
5.9 Parameters for Action after Cycle ............................................................................. 32
5.10 Feed axis Parameters .................................................................................................... 32
5.11 Other Parameters ............................................................................................................ 33