Weinmann Module System - Page 34

34 CPAP MODULE
EN
Stop CPAP therapy
1. Check the oxygen reserve at the contents
pressure gauge of the pressure reducer.
2. Close the oxygen supply valve and wait until the
system is depressurized.
3. Turn dial
5 anti-clockwise until you feel it reach
the stop.
This will prevent the next patient inadvertently
obtaining too high a CPAP pressure.
4. Switch off the CPAP MODULE using toggle
switch
4.
5. Take the breathing mask off the patient.
6. Clean and disinfect/sterilize the device and the
device parts (see “11. Hygiene treatment” on
page 39).
7. Perform a function check (see “12. Function
check” on page 42).