Weishaupt WM-L20/2-A R - Page 79

Installation and operating instruction
Oil burner WM-L20/2-A R (W-FM100/200)
13 Spares
83252902 1/2019-09 La
79-84
Pos. Description Order No.
5.21 W-FM plug
– X3-01 Motor On 716 300
– X3-02 Air pressure switch 716 301
– X3-03 Limit switch burner flange 716 302
– X3-04 Mains and safety circuit 716 303
– X4-01 Oil/Gas change-over 716 304
– X4-02 Ignition unit 716 305
– X4-03 Solenoid valve venting APS 716 306
– X5-01 Min. oil press. DSA58 716 307
– X5-02 Max. oil press. DSA46 716 308
– X5-03 Control circuit 716 309
– X6-01 Start release 716 310
– X6-02 Magnetic coupling - oil pump 716 311
– X6-03 Oil safety valve 716 312
– X7-01 Oil valve stage 2 716 313
– X7-02 Oil valve stage 3 716 314
– X7-03 Start release Gas 716 315
– X8-01 Oil - Gas- display 716 316
– X8-02 Oil valve additional 716 317
– X8-03 Oil valve 1; 2 x 110V 716 318
– X9-01 Gas, PV, V1, V2, SV 716 319
– X9-02 N, PE 716 320
– X9-03 Gas max./min. 716 321
– X10-01 Transformer 230/12V 716 322
– X10.02.1 Flame sensor QRB 716 323
– X10-02.2 Flame sensor QRI 716 332
– X50 CAN-Bus ABE 716 325
– X51 CAN-Bus actuator 716 326
– X52 Transformer 2 x 12V 716 327
– X60 Temperature sensor 716 328
– X61 Actual value U/I 716 329
– X62 Set value U/I 716 330
– X63 Output 4-20mA 716 331
– X70 Proximity switch motor 716 333
– X71 Gas meter 716 334
– X72 Oil meter 716 335
– X73 Frequency converter 716 336