Rotary indexing ring NR
Mounting
Use screws with the property class specified
to mount the product. When determining the
length of the screws, take into account the
loads and forces acting in your application as
well as the characteristics of the supporting
structure to which the product is mounted.
1. Place the product at the mounting site
in compliance with the transportation
instructions and align it according to the
holes and the pin holes.
2. Center the product with the two parallel pins
and then drive in the first parallel pin by one
third.
3. Screw in all screws and tighten them.
4. Drive in all parallel pins (positive fit, the
parallel pin must be in contact with the
housing and the mounting plate/mounting
surface).
5. Tighten all screws cross-wise with the
specified tightening torque.
Mounting instructions_062019_1.0_en
31 / 62
To Next Page
Loading...
Need help?
General
