Rotary indexing ring NR
Mounting
8.5 Displacing the drive housing
WARNING
FALLING PARTS
Failure to follow these instructions can result in death, serious injury, and
equipment damage.
■
Secure the motor so it cannot fall down before loosening the screws.
The drive housing is factory-mounted according to the drive position you specify in your order. The
drive housing can be moved to the permissible drive positions, see chapter 3.6.
1. Remove the cover [1] by removing the
screws.
2. Remove the four screws [2].
3. Turn the drive housing [3] to the required
position (the illustration shows the drive
housing turned by 90° to the inside).
32 / 62
Mounting instructions_062019_1.0_en
To Next Page
Loading...
