Rotary indexing ring NR
Mounting
Mounting a rotary ring
A rotary ring may only be mounted via the fit holes or with centering fits and threads.
1. Place the rotary ring onto the output flange.
2. Center the four parallel pins [1] and then
drive in the first parallel pin by one third of the
way.
3. Screw in the screws and tighten them.
4. Fully drive in all parallel pins.
5. Tighten the screws cross-wise with a torque
wrench, see chapter 8.2.
Mounting instructions_062019_1.0_en
35 / 62
To Next Page
Loading...
