Rotary indexing ring TR
Safety
Hazard symbols may also be attached to the product.
Hazard of hot surface
Hazard of magnetic field
No access for persons with heart pacemakers or other medical implants
2.3 Responsibilities of the system integrator and/or operator
The system integrator (the person who incorporates the product in a machine pursuant to Directive
2006/42/EU, i.e., for example, the machine builder) and/or the operator must ensure the following:
■
The application and use of the product must be limited to the specified intended use.
■
In the integration of the product, all functional safety requirements must be met.
■
All directives, standards, and safety regulations, including all regulations concerning workplace
safety and prevention of accidents, applicable at the installation site of the product must be complied
with.
■
Any type of work whatsoever on and with the product may only be performed by qualified personnel.
■
The product may only be operated when it is in flawless, fully functional condition.
■
All safety equipment must operate as required and planned.
■
The personal protective equipment for the personnel/operator must be available and must be used.
■
The mounting instructions and all applicable documents must always be accessible in their entirety
to the personnel at the installation site of the product.
■
Safety instructions, labels, and any other information attached to the product must not be removed.
■
A complete manual must be available for the machine into which the product is incorporated; this
manual must describe all types of work on and with the machine and contain all information relevant
with regard to the product.
If the system integrator himself is not in the position to comply with any of these obligations, the system
integrator must impose compliance with these obligations on the operator.
2.4 Qualification of personnel
Only trained personnel who have fully read and understood the mounting instructions and all applicable
documents for the product may perform work on and with the product.
This trained personnel must have sufficient technical training, knowledge, and experience, and be able
to foresee and detect potential hazards that may be caused by using the product.
All trained personnel working on and with the product must be fully familiar with all directives,
standards, and safety regulations that must be observed for performing such work.
Mounting instructions_062019_4.0_en
9 / 79
To Next Page
Loading...
Need help?
General
