Welotec TK800 - Page 34

3.1.5.4. AAA Settings
3.1.7 3.1.6. Config Management
Under Administration > Config Management the current configuration can be saved, an existing configuration can
be uploaded or the router can be reset to the default configuration.
Importing an existing configuration
To import an existing configuration, an existing configuration file must be selected via Browse…. Aer the correct
file has been selected, the configuration can be imported to the router via Import. Aer successfully importing the
configuration, the router displays a button forrestarting. Aertherestart the routerwillhavethenewconfiguration.
Saving an existing configuration
Via Backup running‑config the current configuration incl. the unconfirmed changes during operation can be down‑
loaded. Via Backup startup‑config the configuration can be downloaded without the unconfirmed changes.
Automatic saving
If the checkmark in front of Auto Save aer modify the configuration is set, all changes in the router are immediately
active and are also available aer reboot. If the checkmark is not set, the changes will be lost on reboot. However,
the changes can alternatively be saved via Save Configuration, the bottom item in the le navigation.
Reset configuration to factory defaults
Via Restore default configuration the configuration of the router can be reset to the default settings.
Encrypt passwords in the configuration file
To prevent passwords in the configuration file from being displayed in plain text, check Encrypt plain‑text pass‑
word.
Back up the running‑config including the private key
Um die running‑config zusätzlich mit den importierten privaten Schlüsseln (private key) aus der Zertifikatsverwal‑
tung zu sichern, setzen Sie den Haken bei Backup running‑config with private key
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 33