1.8
SUZUKI MEGABUSA DONOR LIST
PARTS REQUIRED
:-
- Engine & Gearbox Complete (With Number.)
- Throttle Linkages & Injection Assembly
- Full Engine Wiring Harness* (Requires Modification – See Note Below)
- E.C.U.
SENSORS:-
- Intake Air Pressure Sensor
- Atmospheric Pressure Sensor
- Intake Air Temperature Sensor
- Starter Motor Assembly
- Starter Motor Relay
- Chain Sprocket Nut & Washer
- Ignition Coils x 4 (These are part of the Spark Plug Caps)
- Regulator / Rectifier Unit
- Fuel Pump Relay
- Dash Complete (For Fault Finding)
- Photo Copy Of Donor Log Book If Available
IMPORTANT NOTES
:
- Never purchase engines with any damage to casings or without
IDENTITY NUMBERS.
- Establish if the safety recall has been completed on Timing Chain
Tension Adjuster (Suzuki Warranty). If this has been done there will be a
‘RECALL COMPLETION’ LABEL attached under the pillion seat on the left
hand side of The ‘U’ LOCK storage area.
Example:-
*Note*
The Wiring Loom will require modification before installation.
WESTFIELD SPORTS CARS can carry out this modification for a fee.
To Next Page
Loading...
