1.7
TOOLS you will NEED
1. Combination Spanner Set : 5/16" To 3/4" A/F Imperial
2. Combination Spanner Set : 8mm To 19mm A/F Metric
3. Socket Set : Imperial And Metric
4. Torque Wrench : 1/2" Square Drive : Range O-100 lb ft
5. Drill Set To Include : 5/32", 3/16", 1/4" & 5/16" Drill Bits
6. Metric `Allen’ Keys : 1 Set
7. Socket Drive `Allen' Key : 6mm
8. Socket Drive `Allen' Key : 8mm
9. Circlip Pliers : Internal And External
10. Tap : 1/2" UNF
11. Tap : M18 X 1.5mm
- (Note The M18 X 1.5mm Tap Is Only Required To Clean Out The
Residual Powder Coating That May Have Been Left- In The Top
Wishbone Threads)
12. Hole Cutter : 1 ¼" Diameter - Steering Column
13. Hole Cutter : 1 ¾" Diameter - (45mm) Loom
14. Hole Cutter : 2" Diameter - Gear Stick
15. Pop Rivet Gun
16. Brake Pipe Bending Tool
17. Rivnut Fixing Kit
18. Electric Drill
19. 12" Hacksaw
20. Engineering Hammer
21. Centre Punch
22. Hide Hammer
23. Two 'G' Clamps
24. Bench Vice : Machine Type
25. Flat Blade Screwdrivers : 1 Set
26. Phillips Screwdrivers : 1 Set
27. Round File : 5/16” Diameter
28. File : 12” Long Flat Blade File
29. Tape Measure
30. Metal Cutters
IN ADDITION, for the WESTFIELD `SEi’ & XTR2 ONLY:
1. 41mm A/F METRIC Socket
2. Torque Wrench, ½” Square Drive with a Range of 250 lb ft.
(If necessary, HIRE both the Socket and Torque Wrench when required)
To Next Page
Loading...
