4.3
SECTION 04 - CHASSIS WIRING LOOM
- IT IS RECOMMENDED THAT YOU ALWAYS USE THE WESTFIELD CHASSIS WIRING LOOM.
- DO NOT USE metal clips to support the wiring loom or allow the wiring loom to make contact
with any moving parts or sharp edges.
Tools Required:-
– Electric Drill / 4.1 Dia Drill Bit / Pop Rivet Gun / 1” Masking Tape / Fine Pointed Marker Pen
/ Side Cutters / 3mm Allen Key / M8 Combination Spanner
Parts Required:-
- Westfield Chassis Loom / Loom Saddles / 4.1mm Dia x 10mm Long Closed Pop Rivets / Cable
Ties / 4 x M5 x 25mm Button Head Screws / 4 x M5 Nyloc Nuts / 4 x M5 Plain Washers / 4 x
Aluminum Spacers / 1” Foam Tape
Step 1: Fuse Box Mounting Plate
View From Passenger Side
Step 2: Loom Mounting Side Panels
4 Fuse Box Mounting Lugs
(Welded To The Top Frame
Chassis Rails)
i/ Position Panels As Shown
ii/ Trim Panels to Fit Correctly
iii/ Drill Through Panels Into Chassis
Rail (Shown By ‘ ’)
Loom Mounting Side
Panels
NOTE
Loom
Shown
For Ref.
Only At
This
Stage
iv/ Rivet Through Loom Saddles &
Panel Into Chassis To Secure
To Next Page
Loading...
